How Big Of A Hole Do I Need For A 4×4 Post?

How deep should a hole be for a deck post?

Dig the holes six inches deeper than the required frost line depth for your area, and slightly wider than the concrete footer tubes you’ll be using..

Should I use 4×4 or 6×6 deck posts?

A short 4×4 can carry an awfully big load, and many deck builders use 6×6 posts as a standard, regardless of the height or load of the deck. … Multiplying that area by the expected load tells you the weight a post is expected to carry.

Will pressure treated wood rot if buried?

Pressure-Treated Wood Makes the Grade Pressure-treated wood in contact with the ground needs the most protection, and will rot in just a few years if you use the wrong grade. … If your wood will touch the ground or be buried, you should get the highest grade you can, up to .

How deep does a 4×4 fence post need to be?

The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet). Add about 6 inches of QUIKRETE All-Purpose Gravel into the bottom of the hole.

How big should the hole be for a 4×4 post?

A general rule of thumb is to dig the diameter of the hole at least 3-4 times the diameter of the post. For example, if setting 4 x 4 wood posts, dig holes 9-12″ in diameter. Posts should be centered in the hole and the posts should always have concrete under them.

How many bags of concrete do I need for a 4×4 post?

Mix two 50lb bags of concrete with water in a mixing tub or 5-gallon bucket. Add concrete into the hole and around the 4” x 4”. Depending on your climate, let concrete set up for 24 – 48 hours.

Is fast setting concrete weaker?

Fast-setting concrete isn’t just simple and fast, it’s also durable and strong, reaching 4000 psi — or pounds of force per square inch —after a month. That’s stronger than the concrete used for foundations on most homes.

Can you put dry concrete in a post hole?

Fast-setting concrete is ideal for setting posts because there’s no mixing—you simply pour the dry concrete from the bag right into the hole, then add water.

How long will a treated 4×4 post last in the ground?

If you find the RV posts I mentioned earlier, they are steel, treated and when put in concrete will last 25 years or more. It will not last long (7 yrs max) if the bottom of the post is wet. If you place stone at the base of the post, it should last 20+ yrs.

How many posts do I need for a 12×16 deck?

Measurements and Initial Framework To measure out your deck and determine your footings, you will need batterboards and mason’s string. A standard deck will need four footings parallel to the house, but they will need to be temporarily braced by 6 inch-by-6 inch posts.

How many posts will a bag of Postcrete do?

“Usually one bag of postcrete per post is enough, however you can use a two bags per post if you feel this is needed. The instructions are on the bag.”

Is 2 feet deep enough for fence posts?

The minimum depth that you should dig your fence post holes for panel sections is 2 feet. A general formula is to dig the holes one-third to one-half of the post’s aboveground height. The deeper you dig the holes, the more stability your fence has, but you must also purchase longer posts.

Is 18 inches deep enough for fence post?

The general rule of thumb when setting a post is that the depth of the post’s hole needs to be one-third to one-half of the actual above-ground height of the post. … For our six-foot-high fence post, we would need a hole that’s 36 inches deep and 12 inches in diameter.

Why deck posts should not be set in concrete?

A deck post should always be placed on top of footing, not inside concrete because it can break. When concrete is poured around a deck post in this way, the post will rot due to moisture buildup by the soil. …

Will a wood post rot in concrete?

A: Actually, your point is well taken. Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. … The concrete at the top should be sloped away from the post to grade level to avoid water pooling around the base.